07-23-2020, 09:13 AM
Hello guys, I've already sent an email to Harrison's support but I wanted to share this with you and see if anyone had same issue.
I used just 1 time my control surface without any issue in one mix to write all the automation, and in an empty one, just to see how the encoders are mapped about EQ, Compressor, etc.
Everything worked just fine.
I unplugged the surface and today I wanted to use it again, not possible. The only thing that works are the master fader and the transport controls.
Anything else (faders, track select, solo, muting, eq, bank slides, etc) just doesn't works.
Apparently the mapping has gone? I mean, if I try to edit manually in the "plain" column I can make that for example the EQ encoder when pressed arms the track 1 for recording. So the surface is still working but suddenly I cannot use it.
Has someone fighted with this before? Also updated to V6.1 and that doesn't fixed the problem.
Thanks!!
I used just 1 time my control surface without any issue in one mix to write all the automation, and in an empty one, just to see how the encoders are mapped about EQ, Compressor, etc.
Everything worked just fine.
I unplugged the surface and today I wanted to use it again, not possible. The only thing that works are the master fader and the transport controls.
Anything else (faders, track select, solo, muting, eq, bank slides, etc) just doesn't works.
Apparently the mapping has gone? I mean, if I try to edit manually in the "plain" column I can make that for example the EQ encoder when pressed arms the track 1 for recording. So the surface is still working but suddenly I cannot use it.
Has someone fighted with this before? Also updated to V6.1 and that doesn't fixed the problem.
Thanks!!
Estudio Dream Big
Mixbus 32c V6 - Intel i5 2390T - 6GB RAM - HDD 7200 RPM - Tascam US 16x08 - Win7
Nothing can go wrong!
Mixbus 32c V6 - Intel i5 2390T - 6GB RAM - HDD 7200 RPM - Tascam US 16x08 - Win7
Nothing can go wrong!