07-08-2020, 03:24 AM
Hi all,
I am relatively new to Harrison Mixbus so apologize if there is an obvious answer to my issue.
I am using a Universal Audio Apollo setup with Windows 10 and Mixbus 32c V6. When I try to export a completed mix, at the very end of the export I get an error stating that the UAD Hardware is not found. After the message is displayed for about 2 seconds the Mixbus session shuts down and I need to start mixbus again. I am running Cakewalk By Bandlab and Protools on the same system without any issues.
If I connect my MAC to the Apollo running mixbus 32c V6 I am able to export without any issue.
Has anyone else come across this.
Thanks,
David
I am relatively new to Harrison Mixbus so apologize if there is an obvious answer to my issue.
I am using a Universal Audio Apollo setup with Windows 10 and Mixbus 32c V6. When I try to export a completed mix, at the very end of the export I get an error stating that the UAD Hardware is not found. After the message is displayed for about 2 seconds the Mixbus session shuts down and I need to start mixbus again. I am running Cakewalk By Bandlab and Protools on the same system without any issues.
If I connect my MAC to the Apollo running mixbus 32c V6 I am able to export without any issue.
Has anyone else come across this.
Thanks,
David