How do I clear fader automation on a mixbus?

[Clint]

I'm using a MCU that is so old that it says emagic on it still!

I got the dread garbled automation so that the faders are jumping all over the place and when this happens on a normal track, I just clear the automation the normal way in the editor.

But I'm having the jumpy fader illness on a mixbus and I don't know where to look for the menu for clearing the automation, since the mixbuses are not in the editor. I know this must be easy.

[Dingo]

Reveal the automation lane you want to delete, right mouse on the header of the automation lane... clear to delete all automation on that lane.
   

[Clint]

But where is the lane for a Mixbus? I can clear a normal track with ease because the track has a lane-
but I see no lane for the busses. There are faders in the mixer, but no lanes in the editor.

[Dingo]

On the Edit page, shift L to reveal the Edit list RHS, make the Mixbus you want visible in the Editor, then use A to reveal automation lanes on the Mixbus you want.

       

[Clint]

That’s what I needed!! Thanks a million!
I wish I knew how/why the automation gets so whacked sometimes.

Anyway, that fixed my problem just fine! Thanks again!

[Dingo]

I wish I knew how/why the automation gets so whacked sometimes.

I have seen that sort of crazy automation data when a touch fader is not responding properly whilst in Touch mode.
It is as if the fader is dropping in and out of write hundreds of times a minute.
Try calibrating your faders if possible, also with capacitive touch faders dry weather or very dry hands can sometimes cause poor contact.