(04-13-2020, 02:34 PM)whiskeynipple0088 Wrote: thank you for posting the solution - even though there really wasnt one.
was the automation written via physical fader movement? - just wondering cuz I have not yet tried writing automation via my Qcon Pro X faders.
The Qcon Pro G2 is fantastic and solid. Mixbus gives me direct access to all important parameters right away and just the one I need. With Cubase it's heavily overloaded with a journey through endless subpages.
My mistake was:
"You dont do anything unless you did a calibration"
1. Turn the device off. Hold the Rec Button on channel 2 and turn it on.
Set all values with the rotating knobs to 185. Press(!) the rotating knob no.8 to confirm. Turn off.
2. Hold Rec. Button no. 7 down and turn the device on. Move each fader up and down a bit. Turn it off and on again. (No confirm needed).
So I made a recording of automation, wondering the nuts fader, start whining, but did not look to the automation curve, who record the crap with uncalibrated faders. Afterward, you can calibrate as much as you want. The garbage has been written already.
So I'm ready to make a new song:
"You give me scrub Mr. Harrison"