08-15-2017, 10:50 AM
(This post was last modified: 08-16-2017, 02:14 PM by Ben@Harrison.)
Hello again!...I just upgraded to 32c4, but unlike all previous versions this time is not asking me, when opening a session, the sample rate and the inputs and outputs i´m going to use...
I guess it identifies the sample rate by itself, but is not doing the same with my interface...
I alreayd check on Properties and Preferences...
Where is it???
I guess it identifies the sample rate by itself, but is not doing the same with my interface...
I alreayd check on Properties and Preferences...
Where is it???