12-11-2016, 08:04 PM
Hello, MB Support -
I think I just discovered a minor bug in MB 3.7 (Have not tried this with MB 32C).
Take any ole multi-track mix.
In the editor window, select all tracks via CNTL-A
Slide all tracks to the right a couple seconds.
Play back the mix.
Everything sounds good... except...
I had an automated fader associated with a mixbus that did not slide.
Only way to line that up where it should have occurred was to manually move
all of the control points in that automation track. I only had (4) to move so it
was not any big issue. But I was surprise that:
1) Those control points did not slide right with everything else and
2) I could not just slide that automation track to the right (something I haven't
tried to do before. I had to move each control point.
Other than that.... everything else in 3.7 seems to be working fabulously!
Cheers!
Patrick
I think I just discovered a minor bug in MB 3.7 (Have not tried this with MB 32C).
Take any ole multi-track mix.
In the editor window, select all tracks via CNTL-A
Slide all tracks to the right a couple seconds.
Play back the mix.
Everything sounds good... except...
I had an automated fader associated with a mixbus that did not slide.
Only way to line that up where it should have occurred was to manually move
all of the control points in that automation track. I only had (4) to move so it
was not any big issue. But I was surprise that:
1) Those control points did not slide right with everything else and
2) I could not just slide that automation track to the right (something I haven't
tried to do before. I had to move each control point.
Other than that.... everything else in 3.7 seems to be working fabulously!
Cheers!
Patrick