05-18-2016, 03:55 PM
Hello, longtime Ardour user, and now finally getting Mixbus setup and very happy with it.
The only significant problem I've had is that I have one session where whenever I solo any track, track 5 continues to play through the assigned busses and the master channel. I have looked at the signal routing on both qjackctl as well as the Audio Connections in MB3.
There was a mysterious third channel in addition to left and right outs for track 5, however this does not seem to be connected to anything. I have deleted the third out, but it didnt change anything.
Also, the master doesn't even show up in Audio Connecitons or qjackctl connections. Is that supposed to be the case?
I was convinced this was some boneheaded mistake on my part, but after looking at the routing, I'm scratching my head.
Any suggestions? Thanks!
The only significant problem I've had is that I have one session where whenever I solo any track, track 5 continues to play through the assigned busses and the master channel. I have looked at the signal routing on both qjackctl as well as the Audio Connections in MB3.
There was a mysterious third channel in addition to left and right outs for track 5, however this does not seem to be connected to anything. I have deleted the third out, but it didnt change anything.
Also, the master doesn't even show up in Audio Connecitons or qjackctl connections. Is that supposed to be the case?
I was convinced this was some boneheaded mistake on my part, but after looking at the routing, I'm scratching my head.
Any suggestions? Thanks!