MIDI track to AUDIO tracks

[Ivanoff]

hi,
try to record a MIDI track with VI ( Sample Tank 2.5) to an audio track 1.
Don't understand the routing section.
Thaks for some help

Windows 8.1

[Guest]

On your audio track, left click on the input button at the top of the channel strip and select disconnect to make sure that there are no unwanted connections. Left click again and select 'Routing Grid'. Click on the 'Mixbus Tracks' tab and you should be able to see your MIDI tracks audio outputs. Connect these up to your audio tracks inputs.

Also see here - http://www.harrisonconsoles.com/mixbus/m...c/jack-i-o

[Dingo]

hi,
try to record a MIDI track with VI ( Sample Tank 2.5) to an audio track 1.
Don't understand the routing section.
Thaks for some help

Windows 8.1

Ivanoff,
not sure if this will help, but Audio Connections Manager http://www.harrisonconsoles.com/mixbus/m...c/jack-i-o might .
It's the router that enables you to patch sources and destinations to each other and vice versa .
In the first pic, Sources are on the right, Destinations are on the bottom.
Click to patch or un-patch any device to any channel input, mixbus etc.

[Ivanoff]

thanks for the reply. Following your advice but This is what I have on the Audio Input Track
and no sound on the audio track
[attachment=294]

[Ben@Harrison]

The audio-track needs to be record-enabled .... ?

[youki]

Or to click on "Entrée" at the top just near by the record enable knob ?

[Ivanoff]

Well, I made a try with FM8, which have only 2 outputs, and that's work fine.
I can see the two outputs : L&R and I can connect the audio track

It seems it is an issue with ST 2.5 et Addictive Drum with their 16 outputs.

I think the best solution is to make an export of the MIDI file in wave format.

Another surprise whith a MIDI track. The level in the Sample Tank canal 1 is now 0. After two days of session. Don't know why, and don't find the way to reach 90. Try different automations, but when I start playing again, hpp : level = 0. And when I make some changes : presets or connexions, no more sound; I have to click in the outputs master on the outputs choice.
I think I will make a small break with Mixbus3.

On the other hand I can say that I like the sound of my mix in Mixbus. Like the EQ and compressions. I keep it for my final mix and wait for the vers 3.1

So, thanks for your help