Mixbus, Mixbus32C v9.1.153 now available!

[jeff_sloan]

Sadly, now EVERY time I re-open MB, I have to re-connect the metronome to the outputs.
What gives?

I am not seeing this issue.  Can you email support with screenshots/video showing the issue?

Hi Nathan,
Hope all is well with you guys!

Will do, but it is this:
Open MB32c, this is what the setting is:
MetronomeNotConnected.png

Change it to send to main output, this is what it is set to:
MetronomeConnected.png

Save, close, and re-open program and session, back to MetronomeNotConnected.png.

The manual even says it will sometimes get disconnected, but I am not touching the monitor section, and this is EVERY time, not sometimes.
Manual.png 

Of course this is probably another case of delete the prefs and start over.
I will let you know if it fixes it.

Thanks,

[jeff_sloan]

Deleting the prefs folder didn't fix it, and I get the screen shotted errors every time I open it.
   

[Dingo]

What I am seeing is that if I leave the metronome enabled, save quit re-open and the routing to my hardware persists.
If I disable metronome save quit re-open the hardware patch has gone.

[jeff_sloan]

It doesn't stay if I leave it enabled. I have left it enabled every time. But thank you Dingo!

[Dingo]

Interesting.... I am running the ARM build of 32Cv9.1.153 on Mac mini M1 with Ventura 13.2.1 so I don't understand the differing results.

[jeff_sloan]

Me either. Maybe the difference being the thunder bolt interface? What do u think of the two port errors on startup?

[Dingo]

Me either. Maybe the difference being the thunder bolt interface? What do u think of the two port errors on startup?

Sorry cannot comment on the backend errors. Google pointed to Ardour forum and a reference to MIDI... but not sure... maybe Nathan can comment.
Have you tried disconnecting the TB interface and just testing with internal audio ?

[jeff_sloan]

No, but I can give it a shot...

[Tassy]

In 9.1.72 it was corrected and the "input" section if saved "not seen" was saved in the ardour and reopened without it well.

in 1.96 and 1.153 the input section always appears even if the session was saved when not chosen to see it.

best
Tassy

[jeff_sloan]

No, but I can give it a shot...

I find Asio, usb, and none, not sure where internal audio is...
But after switching to a higher buffer (The 2626 does not have hardware monitoring capability), the metronome stays connected.
Switching back to lower buffers doesn't make it lose the connection though, which is weird. 
But I still get that Backend port error once or twice every time the audio engine starts.

Haven't had a single crash through many hours of recording and editing sessions so far though.