Harrison Mixbus Forum

Full Version: Automation gain line
You're currently viewing a stripped down version of our content. View the full version with proper formatting.
It was an issue long a go and I think it was solved but it is here again

In the automation track the gain line cannot be seen where it is only after it was adjusted somewhere.
It can be seen only as far as the last (in timeline) adjusted range right border.

I would like to see the normal line whenever I open a track for a parameter  without doing a blind mouse hovering into nothing and see what I dam doing only after the not visable line in the selected region has been moved.
I hope it makes sense, since it is practical
Thanks
Tassy