(02-02-2019, 11:36 AM)durutti Wrote: [ -> ]can you provide an how to set this up.
No problem.
See my signature for my system details.
Install zita-ajbridge from the repositories.
I have one Zoom L12 that are capable to act as an audio interface AND a recorder(12 channels + 2 master out) simultaneously. This show up in Jack(QjackCtl) advanced setup as hw:L12,0
My Zoom H6(6 channels) audio interface or field recorder shows up in QjackCtl advanced setup as hw:H6,0
I can select only one of them as my audio interface. In this case I use the H6 as primary interface and bridging in the L12.
Here's the main setup tab in QjackCtl:
[
attachment=1987]
I will only record in this session so I use the default frames 1024 and periods 4
The advanced tab look like this with the H6 as primary device, remember to define the input and output channels correctly:
[
attachment=1988]
In the option tab I put in the command to start Zita bridge after jack have started and it looks like this:
[
attachment=1989]
The start command in detail:
zita-a2j -j L12 -d hw:L12,0 -r 48000 -p 512 -n 4 -c 14 &
Where:
-j L12 (my name to the audio interface)
-d hw:L12,0 (reference to the physical ALSA device)
-r 48000 (Sample rate - same as primary device)
-p 512 (frames - should be half of primary audio interface)
-n 4 (periods)
-c 14 & (number of channels)
Start jack and then mixbus. In mixbus you now see this routing grids:
[
attachment=1990]
[
attachment=1992]
This should be it.