3 extenders and 1 Mackie controller

[duckvp]

Hi
I'm new on mixbus x32c.
I have 1 x-touch and 3 x-touch extenders how can I set up this 4 controllers in x32C.
I've found for 1 Mackie controller and 2 extenders but not for 1 mackie controller and 3 extenders.
Excuse my english, I'm french.

[madmaxmiller]

Hi
I'm new on mixbus x32c.
I have 1 x-touch and 3 x-touch extenders how can I set up this 4 controllers in x32C.
I've found for 1 Mackie controller and 2 extenders but not for 1 mackie controller and 3 extenders.
Excuse my english, I'm french.

Try this:
- find your device file which comes closest to your configuration
- in Linux this would be found in /opt/Mixbus32C-5.2.191/share/mcp/
- copy and rename a file, for example: copy xt+mc+xt.device and rename it into maybe xt+xt+mc+xt.device (which should reflect yout config)
- open the file:
8<----------------------------------------------------------------------
<?xml version="1.0" encoding="UTF-8"?>
<MackieProtocolDevice>
<Name value="Two Extenders with Mackie Control in Center"/> <<======= change
<Strips value="8"/>
<MasterFader value="yes"/>
<TimecodeDisplay value="yes"/>
<TwoCharacterDisplay value="yes"/>
<Extenders value="2"/> <<======= change
<MasterPosition value="2"/> <<======= change
<GlobalControls value="yes"/>
<JogWheel value="yes"/>
<TouchSenseFaders value="yes"/>
<NoHandShake value="yes"/>
<HasMeters value="yes"/>
</MackieProtocolDevice>
8<------------------------------------------------------------------------

In case xt+xt+master+xt you would change the number of extenders to 3 and also the position of the master unit to 3... I think you get it
Save file and with the next Mixbus start you should find a Mackie configuration which you named in the file and be able to connect and use.

Good luck!

MMM

[Armando Rivera26]

Hope this makes it easier to Understand.