07-23-2022, 05:12 PM
Hi Guys,
So I am working on Mixbus 32c (v7.x still, not upgraded yet) and I am using Open Stage Control (fantastic platform) leveraging the OSC messaging.
I use it a lot for editor and meter monitoring, using the LEDs, but I wanted to setup a controller page for a PLUGIN.
The idea here is, I use an SSL Bus Compressor regularly and I wanted to map those controls globally between Open Stage Control and the plugin, so if I open the plugin on Strip/2 then the controls will work, just as they would, if I was working on Strip/10.
So, regardless of where I am using the SSL Bus Comp, I have a standard set of controls in my OSC page that I turn to and manipulate the parameters that way.
I'm seeing lots of OSC messages coming in when I trigger "/refresh" but I am having a hard time, trying to map the plugin parameters to the OSC buttons and faders globally.
Any help is greatly appreciated
Def
So I am working on Mixbus 32c (v7.x still, not upgraded yet) and I am using Open Stage Control (fantastic platform) leveraging the OSC messaging.
I use it a lot for editor and meter monitoring, using the LEDs, but I wanted to setup a controller page for a PLUGIN.
The idea here is, I use an SSL Bus Compressor regularly and I wanted to map those controls globally between Open Stage Control and the plugin, so if I open the plugin on Strip/2 then the controls will work, just as they would, if I was working on Strip/10.
So, regardless of where I am using the SSL Bus Comp, I have a standard set of controls in my OSC page that I turn to and manipulate the parameters that way.
I'm seeing lots of OSC messages coming in when I trigger "/refresh" but I am having a hard time, trying to map the plugin parameters to the OSC buttons and faders globally.
Any help is greatly appreciated
Def
Def Acres
Def Acres Designs
Harrison Mixbus 32c v7.x
MBP 13" | HP Z620 | DVS |
Def Acres Designs
Harrison Mixbus 32c v7.x
MBP 13" | HP Z620 | DVS |